How to use: upload a floor plan PDF → check the rooms we found →
read total TR, L/s and download or print the report. All calculation happens inside your browser.
Start here
1. Project and design conditions
Every value you change is used immediately. Results update as you type.
Construction and system assumptions (U values, safety factor, supply ΔT; defaults are fine to start)
Design basis
what this load stands onEvery figure, with its source and its status
2. Upload a drawing or a room schedule
Accepted files: .pdf floor plan drawings, and .csv / .tsv /
.xlsx room schedules (from Revit or Excel). You can upload many files at once.
Rooms found are added to the table below — existing rows are not deleted.
Reading PDF drawings and room schedules in your browser
PDF CSV
Drag and drop your drawing or room schedule here
PDF drawing, or CSV / TSV / Excel room schedule ·
click to choose files
Working...
0 parser note(s) — click to read
3. Draw rooms on the plan
Set the drawing scale, then use Draw shape to add a room — one tool, two gestures.
Drag over a room for a plain rectangle: the area is measured from the rectangle
and that scale, and it becomes a new room straight away. Click each corner to
trace a room with any number of sides: click the first corner again (or double-click, or press
Enter) to close it, and choose which room the shape belongs to — a new room, or an existing row
whose area the shape then sets. The boxes below are the rooms you have placed;
rooms found by reading the PDF stay in the table, but Place all rooms on the plan gives
every one the drawing names a locator box where the sheet names it, sized back from that room's
own area (it is a locator, not the traced room boundary). Trace real outlines reads the
plan's own wall lines and gives the rooms it can trust a real outline shape — a room whose shape
the plan does not enclose, or whose traced area does not agree with the stated one, keeps its
box. Remove outlines takes those shapes away again and leaves the boxes alone.
A drawing that prints room names but no areas: Fill areas from the drawing
measures an area from the plan's own outline, but only when exactly one room name sits inside one
closed shape — it says what it filled and what it left alone, and Undo fill puts it back.
Remove placed rooms takes those
boxes away again and never touches the rooms you drew yourself. Click a box in
Select / edit to open that room's breakdown. In
Select / edit you can also drag a room to move it, drag a corner to resize it,
press Delete to remove it, and middle-drag or hold Space to pan the sheet.
All of this stays in your browser, and the drawing is kept here too — reload the page, or come
back tomorrow, and it is still here with your boxes on it.
Page 1 of 1
100%
Working...
This shape is room:
A bigger or smaller shape changes that room's area, and the total load with it. Leave it on
(new room) to make a new room instead.
Grey values are the defaults we calculated from the room type — the load uses them.
Type your own value to override. Click a row to see the load breakdown.
Bulk edit (applies to the rows shown above):Tip: use the filters to pick one level first.
In
Level
No.
Room name
Space type
Area m²
Height m
People
Light W/m²
Equip W/m²
Orient.
Ext wall m²
Glass m²
Roof
Partition m²
Sensible (W)
Latent (W)
Total (W)
TR
Supply air (L/s)
Area/tonne (m²/TR)
Source
No rooms yet. Upload a PDF drawing or a CSV / Excel room schedule above, click
Try sample drawing, or use Add room manually.
Load breakdown
6. Save and export
Your work is saved automatically in this browser (local storage). Opening the page again restores it.
Use Save project to keep a file copy or to move it to another computer.